8. After the last cutting, manually shift the beam back, and push the release button of the press switch to take out the plate;
9. Clean the table.
10. Attention:
A. Lubricating oil should be filled before starting the machine every day;
B. The depth of the single cutter groove is 0.33, 0.22, 0.15, 0.15, 0.15, 0.15, 0.15, 0.15, 0.15, 0.10 and 0.10 respectively;
C. the "groove preparation" button is the button to prepare the groove before the fully automatic groove planing machine. Do not press this button during the grooving process.
D. After entering the new program, press the "emergency stop switch" to open it, and then press the "Forward tool holder" button to gouge;
E. When the bending Angle is less than 90 degrees, the slotted groove should be expanded with an obtuse knife;
F. The switch in the electric cabinet should not be switched on and off frequently. Each time the machine is shut down, just dial out the key.
G. Air duct shall be used to clean the iron filings at any time during the grooving process, and there shall be no sundries under the fixed frame of the platform;