I. Concentrate on working time, strictly observe operating rules, and ensure safe operation.
Second, cut off the power supply before adjusting the equipment.
3. Make accurate adjustment according to the required size. Special tools should be used during adjustment.
Four, pay attention to the pressure between the Angle cutting blade and the bottom shaft, after the blade and cardboard gently cut. Micro adjustment to prevent injury of knife edge.
5. Before work, the paper feeder should be adjusted to the same straight line and parallel to the working shaft.
Vi. During adjustment, it shall be noted that the paper splitting knife shall be used in a complete set with moderate clearance and suitable pressure for line pressing wheel.
7. After adjusting the working size, check whether the locking parts should be locked and whether the chain tightness is appropriate. Remove all miscellaneous items on the equipment. 8. Make sure the oil level of the exposed oil cup is appropriate when starting the machine, and then start the machine to run at a low speed to observe whether the rotation is abnormal. Improve the working speed after all transmission parts are completely lubricated and there is no abnormal sound of the machine rotation.
9. Before production, pre-trial production shall be carried out. After continuous inspection of multiple finished products and confirmation of compliance with the requirements, formal production shall be carried out.
10. Be careful in the operation process. The work clothes should be fastened and avoid the knife edge.
11. Check frequently whether all parts are worn or do not meet the requirements, and repair or replace them in time if necessary.
Pay attention to machine maintenance and lubrication. (1) Ensure the oil level of the tank, and drip regularly. (2) The feeder transmission slider should be refueled once per shift. (3) The connecting gears should be lubricated frequently. (4) The operating bearing should be repaired every six months to once a year and filled with calcium base butter. (5) The regulating vortex rod should be lubricated regularly.
13, each shaft to keep clean, often wipe with oil.
After the completion of production according to the prescribed program stop, and then cut off the power supply.
Fifteen, every day to go to work to wipe the machine, the process of work to ensure that both hands clean, immediately clean up the work of the surrounding environment.